Categories
Payment Information
Information
|
|
|
| Quick Specs: |
| |
- Material: Aluminum
- Construction: CNC Machined
- Bellcrank Arm Styles: Straight, Offset
- Bellcrank Support: Ball Bearing
- Servo Bay #: 2, 3, 4
- Servo Sizes: Standard, 1/4 Scale
|
| Highlights: |
| |
- Bellcrank design utilizing AirWild's patented MLP geometry
- Ball Bearing supported, precision movement
- High precision, CNC machined aluminum bellcrank arm and tray
- Anozided color finish
- Innovative rudder tray architecture offering maximum structrual integrity and lightest assembly weight
- Ideal for use with AirWild 2.5-in. MLP servo arm
|
|
|
At the heart and soul of the tray assembly is an innovative aluminum bellcrank arm employing the patented AirWild MLP control geometry. MLP stands for Minimal Lateral Play and is a patented AirWild design that significantly increases control precision and at the same time reduces play in mechenical movement of pivotal control arm such as servo arm or bellcrank.
To further improve movement accuracy and maximize performance MLP bellcrank arm is mounted on a ball-bearing supported aluminum output shaft. The entire shaft base has lightened features in strategic places to eliminate any dead weight yet without sacrificing structrual integrity.
In addition to those obvious design features, we also thoughtfully address the not-so-obvious, but little nicety to have. As you may have noticed in the photo illustration we added a small notch in the servo mounting cutout. This little extra clearence allows the bulky strain relief of the servo pigtail to easily clear the cutout and make installing servo a snap.
Two servo cutout sizes available. Standard cutout is for all standard case size servos including JR 8611. For those Futaba users, don't worry 'cause we also have a special cutout for your favorite Futaba S9152 high torque digital servo.
|
|
|
|
|
Features Outline
- Bellcrank arm pre-tapped #4-40 holes for securing ball links or other mounting hardware
- Bellcrank arm designed to with 2.5-in. rudder servo arm
- Servo mounting holes pre-tapped for #2-56 screw
- Tray mounting hole accepts #6 screw (0.138 in. dia.)
- Bellcrank arm available in Straight or Swept-Back style
- Servo cutout available for Standard or Futaba S9152 size
|
|
|
Straight MLP Bellcrank Arm
- Maximum 5-in. bellcrank span
- Additional mounting points for 4.5 in. & 4.0 in. span setup
- One bellcrank, three flexible configurations (5, 4.5, 4)
- Use 2.5-in. full servo arm for rudder servo setup
- For non-offset rudder horn setup and/or parallel pull-pull cable application
|
|
|
|
|
|
|
|
Featured Products
|
